Shape the sound
by hand.
Make a broad change to the tonal balance or focus on a small part of the spectrum.
Give a voice more body or take the edge off a bright recording. Adjust frequency, gain and width where they apply, then audition the band or compare the full sound.
Your manual edits remain separate from Algorithmic EQ.
Explore Manual EQ
- Frequency
- Choose the part of the spectrum.
- Gain and width
- Set the amount and reach of the change.
Choose the part that needs attention.
Select a filter and adjust its frequency, gain and width where those controls apply. Use band audition to investigate the selected region.
Manual EQ playground
Select a point to edit
Band 2
Your bands
Mouse and keyboard
Drag a point for frequency and gain. Scroll over a selected point for width or cut slope. Hold Shift for smaller changes, or Alt to move along one axis. Ctrl-click or drag a box to select several points. Use Delete, Ctrl+Z and Ctrl+Y to edit.
01Go broad or narrow
A broad adjustment changes more of the surrounding sound. A narrow adjustment concentrates on a smaller frequency range. Lower Q gives a broader response for a bell filter.
02Choose a filter
Use a bell, low shelf, high shelf, low cut, high cut, notch, band-pass or all-pass. The available frequency, gain and width controls depend on the filter. All-pass changes phase while leaving magnitude flat.
03Compare before you save
Use comparison slots and undo while refining the curve. Your manual edits remain separate from Algorithmic EQ.